FAA Approved Installation Manual for the EDM-960 system
Report No 909
Primary Engine Data Management System
Page 23 of 45 Rev C
Date 12-12-12
3.
Tap
USER
when you see ‘
Do you want to restore user table
?
’ (Note: tapping FACTORY causes the fuel table
stored on the Key Card to over-write any previous user entries in the fuel table. Use FACTORY if you want to start
from the original factory default).
4.
Tap
POINTS
when you see ‘
Do you want to edit the table?
’.
5.
You see
‘
Points in LEFT
’, the current calibration points for the LEFT tank.
6.
Tap/hold
VALUE
to change to the desired number of calibration points for this tank (2 to 5). Each Tank can have a
different set of calibration points. So 5 points for Main and 2 points for Aux.
7.
Tap
TANK
to select the next active tank and repeat previous step. Continue until all tanks ‘points’ have been set.
