ATR833A / P/N 833A-(xxx)-(1xx)
Operation and Installation
28
Dokument-Nr.: 01.1411.010.71e / Revision: 3.00
A short press of
switches to the next configuration item, a long press
of
exits the configuration menu
.
3.6 TST - Test Mode
The last option in the setup mode is the test mode. The test mode is
used by maintenance personnel only for factory-internal calibrations.
ACT
123.450
SBY
118.910
TST mode off
The test mode is activated/deactivated with
.
With active test mode, in normal operation of the radio the lower
display line contains some internal parameters, as shown below:
ACT
123.450
SBY
118.910
VOL 03 H423 V56 E22
Any press of
exits the configuration menu
.
3.7 Master Reset
To reset all configurations back to factory settings, hold both the
and
buttons pressed while switching the radio on with
.
Acivation of the master reset is done with
. After performing the reset,
the confirmation
„successfully“ is displayed, and the radio automatically
restarts.
To leave the menu without performing a master reset, press the key
.
For correct microphone sensitivity configuration, VOX must be
set to 5 previously (for VOX-settings refer to section 0).
Don’t care for volume of the headset’s/speakers output during
this configuration, as this is set separately by INT.
