RIGHT
LEFT
FR
EN
10
11
PLATINIUM
3
BINDINGS
3
2
4
Insert the straplock in the strap and pass the velcro in
the appropriate hole.
Place the first velcro strap on the strap.
Set the height of the footstrap for your size by
adjusting the position over the straplock.
Fold the second velcro strap on top of the first one.
1
You can adjust the position of your
plates to keep them centered on the
board (especially for people using the
Small or Large setups). Simply move the
plates forward or backward while main-
taining the angle chosen.
Once you have chosen the angle and
centering you need, you can place and
tighten the screws with their washers.
CAUTION: make sure the flat side of the
washers is always located towards the
footstrap. The notch located on the op-
posite side will let you see the angle en-
graved onto the plate.
You can adjust the orientation of the
plates on the board to achieve the
angle you feel most comfortable with
when riding. F-ONE recommends an
angle of 12°.
Place the handle above the two inserts
located at the center of the board and
tighten the screws down. The screws
and washers are pre-fitted into the
handle but they can be taken away
by gently forcing them out if required.
All F-ONE Twin-Tips offer three different
feet spacings (stance).
When taking off the pads/plates from
your board, you can fit the screws
and washers in the two holes located
under the pad for this purpose. No more
time wasted looking around for them.
HANDLE
ADJUST YOUR STANCE
ADJUST THE ANGLE OF THE PADS
CENTERING YOUR FEET
TRAVELLING TRICK
SETTING UP THE HANDLE
SETTING UP THE FOOTSTRAPS
To identify the left footstrap from the right one, check the indication written on the label near the tighte-
ning Velcro strap. When setting up the footstrap, this label should be located on the inner side of your foot.
LEFT
RIGHT