F.F. Group MS 125 EASY, Original Instructions Manual

Page: 13 / 72

English | 13
www.ffgroup-tools.com
MS 125 EASY
POWER TOOL USE AND CARE
h
Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it
was designed.
h
Do not use the power tool if the switch
does not turn it on and off. Any power
tool that cannot be controlled with
the switch is dangerous and must be
repaired.
h
Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any ad
-
justments, changing accessories, or
storing power tools. Such preventive
safety measures reduce the risk of
starting the power tool accidentally.
h
Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands
of untrained users.
h
Maintain power tools. Check for mis -
alignment or binding of moving parts,
breakage of parts and any other con
-
dition that may affect the power tool’s
operation. If damaged, have the power
tool repaired before use. Many acci
-
dents are caused by poorly maintained
power tools.
h
Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
h
Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for
operations different from those intend
-
ed could result in a hazardous situation.
SERVICE
Have your power tool serviced by a
qualified repair person using only iden -
tical replacement parts. This will ensure
that the safety of the power tool is
maintained.
SAFETY INSTRUCTIONS FOR SANDERS
WARNING: Do not operate this tool
until it is completely assembled and
installed according to the instructions.
1.
Hold your power tool by the insulat-
ed gripping surfaces, especially when
performing an operation where the
sanding accessory could contact hid-
den wiring.
2. Protect your lungs. Wear a face or dust
mask during operation. Following this
rule will reduce the risk of serious re
-
spiratory injury.
3. Protect your hearing. Wear hearing
protection during extended periods of
operation. Following this rule will re -
duce the risk of serious personal injury.
4. Inspect power cords periodically and
repair them as needed at your nearest
authorized service center. Constantly
stay aware of cord location. Following
this rule will reduce the risk of electric
shock or fire.
5. Check damaged parts. Before further
use of the tool, determine that it will
operate properly and perform its in-
tended function. Check for alignment,
binding or breakage of moving parts or
any other conditions that may affect its
operation. A guard or other part that is
damaged should be properly repaired
or replaced by an authorized service
center. Following this rule will reduce
the risk of shock, fire, or serious injury.
6. Remove all nails from lumber before
using this tool.
7. Do not use the sander to remove lead-
based paints.
WARNING: This product and the dust
created by power sanding, sawing,
grinding, drilling, and other construc
-
tion activities may contain chemicals,
including lead, can cause cancer, birth
defects, or other reproductive harm.
Wash hands after handling. Some ex
-
amples of these chemicals are:
ƒ
lead from lead-based paints
ƒ
crystalline silica from bricks and ce -
ment and other masonry products
ƒ
arsenic and chromium from chemical-
ly treated lumber.