English | 11
www.ffgroup-tools.com
HPW 155i PRO
Check before each use, and at regular intervals,
that all metal fasteners are tight and the product’s
components are in good condition; inspect for bro
-
ken or worn parts.
PRODUCT SPECIFICATIONS
INTENDED USE
If connection is made to a potable water system, the
system shall be protected against backflow.
This high pressure cleaner is designed with a rated in-
put current. The intended use of this product covers
the cleaning of vehicles, buildings, terraces, facades
and garden equipment using clean water and biode
-
gradable chemical detergents. Likewise the product
can be used to clean paving slabs or rain gutters.
This product may not be used to clean clothing, shoes
and other textiles. The water jet should not be directed
against persons, animals, any electrical equipment or on
the product itself. Do not flush any objects which con
-
tain health hazardous materials. The product must not
be run with inflammable, explosive and toxic liquids.
For safety reasons it is essential to read the entire in-
struction manual before first operation and to observe
all the instructions there in.
TECHNICAL DATA
Article Number
47 194
Model
HPW 155i PRO
Max. Pressure
bar
155
Working Pressure
bar
125-135
Working Water Flow
l/h
540
Rated Water Flow
l/h
660
Auto Stop System
P
Motor Specification
Motor Type
INDUCTION
Voltage
V
220-230
Frequency
Hz
50
Rated inlet
W
3.200
Max. water inlet temperature
°C
40
Protection Class
IPX5
Weight
kg
52
Sound emission values determined according to
EN 60335-1, EN 60335-2-79, EN 62233
Typically the A-weighted noise levels of the prod
-
uct are:
Sound pressure level
db(A)
74
Guaranteed sound power
level
db(A)
90
Uncertainty Κ
dB
3
TECHNICAL DATA
Article Number
47 194
Model
HPW 155i PRO
Vibration total values ah (triax vector sum) and
uncertainty K determined according to
EN 60335-1, EN 60335-2-79, EN 62233
Vibration level max:
a
h
m/s²
2,2
Κ
m/s²
0,7
IDENTIFICATION (F
ig
.1)
1. Handle
2. High-pressure hose
3. Power cord holder
4. High-pressure hose reel
5. Power cord
6. OFF/ON switch
7.
Wheel
8. Detergent bottle
9.
Water inlet
10.
Water outlet
11. Pressure regulator
12.
Nozzles
13.
Suction hose and filter
14. Trigger gun and wand
INSTALLATION
WARNING:
Make sure that you replace the black plastic
oil cap on the top of the pump with the yellow dipstick
cap (if not already in position), before operating the
pressure washer.
1. HANDLE INSTALLATION
Fit the handle bar on the base of the high pressure
washer pump, as shown in (Fig. 2, 3).
2. SPRAY WAND INSTALLATION
Fit the spray wand into the gun and rotate it until the
two parts arecompletely locked (Fig. 5).
3. CONNECTION OF THE HIGH PRESSURE HOSE
TO THE TRIGGER GUN
Connect the adaptor of the high-pressure hose to
the trigger gun and twist the nut as indicated to se-
cure the connection (Fig. 6).
4. CONNECTION OF THE GARDEN HOSE TO THE
WATER INLET
Connect the garden hose adaptor(female coupler)
to the water inlet of the pressure washer and then
thread your garden hose(male end) into the garden
hose adaptor (Fig. 7).
