F.Bertazzoni KU24 PRO 1XV, User Instructions

Page: 7 / 16

6 7 3LIOU1LG 3LIOU1LG
to make you familiar with its use. Since these
instructions cover more than one type of hood within
the same series, it may be that reference is made to
components that do not form part of the hood that
you are installing. The hood should be used in the
exhaust version to discharge all the kitchen vapours
and odours out-door of the building. Fittings can
vary from country to country. We reserve the right
to modify the product without any notice always with
the aim of improvements and in compliance with the
relevant norms.
SUGGESTIONS FOR USING THE HOOD IN
EXHAUST POSITION
When an exhaust hood and a heat source requiring
ambient air (e.g. gas, oil, coal stoves, etc.) are used
at the same time, attention is required because the
air necessary for combustion is exhausted from the
room through the hood and this creates depression.
There is no such danger when the maximum
depression in the room is 0,04 mbar. In this condition
no exhaust gas from the heat source is piped. To
assure this condition, make opening in the room
which cannot be closed (doors, windows, etc. are
insufficient) and through which the air necessary for
combustion can freely flow.
Note : All the exhaust ductwork in the apartment
or house should be studied. In case of doubts,
get advice or authorization from the person or
agency responsible for the building.
Note : The efficiency of the exhaust hood
decreases as the length of the ducts and number
of increase. When using the exhaust version,
follow these rules : Do not connect the exhaust
hood to chimneys, flues, and air ducts serving
the room. Before venting into exhaust flues
and ducts no longer in use, ask for approval of
person or agency responsable for the building.
The evacuated air must not be let into a warm
airduct. For the evacuation of the exhausted air
please note official instructions.
INSTALLATION
The hood must be mounted over the centre of
cooking area. The minimum distances between the
cooking area and the underside of the hood are 650
mm (25”19/32).
Warning : If the room contains a flued fuel
burning appliance which is not of the balance
flue type make sure these is an adeguate air
inlet to the room at all times so that fumes are
not drawn the flue.
Note : The distances, however, are subject to the
safety rules in effect in the various countries.
Before drilling the wall make sure that no pipes
or cables will be damaged. If there is no outer
EN
IMPORTANT SAFETY INSTRUCTIONS
Carefully read the following important information
regarding installation safety and maintenance.
READ AND SAVE THESE INSTRUCTIONS for
future reference.
REQUIREMENTS :
120V, 60 Hz. 15A Circuit grounding.
INTENDED FOR DOMESTIC COOKING
ONLY !
IMPORTANT SAFEGUARDS
- Do not connect the exhaust hood to the chimneys,
flues and airducting the room.
- The evacuated air must not be let into a warm air
duct.
- This appliance must be connected to a system
equipped with earth or ground plate.
- When performing maintenance operations,
disconnect the appliance from the field connection.
- Do not do any flambè cooking underneath the hood
- When frying, never leave the pan alone because
the cooking oil could flare up.
- Clean all the surfaces frequently to avoid danger
of fire. To do so use a cloth and or brush soaked in
denatured ethyl alcohol. It also important to remove
and clean or substitute frequently the filter installed
in the hood.
- It advisable to utilise kitchens of the same width
as the hood.
- Do not operate with a damaged cord or plug.
Discard fan or return to an authorized service facility
for examination and/or repair.
- Do not run cord under carpeting. Do not cover with
throw rugs, runners or similar coverings. Arrange
cord away from traffic area and where it will not be
tripped over.
- Do not route cord under furniture or appliances.
- Do not operate any fan with a damaged cord or
plug. Discard fan or return to an authorized service
facility for examination and/or repair. Do not run cord
under carpeting.
- Wiring shall be protected from sharp edges
(including male screw threads), burrs, fins, moving
parts, and other agencies that might abrade the
insulation on conductors.
INTRODUCTION
These instructions are designed to tell you of the
various technical details of your cooker hood and
USER INSTRUCTIONS