22
Owner’s Guide
INTRODUCTION
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
FEATURES
General Information
If the vehicle has accessories that were installed at the
factory, some accessories continue to operate with the key
switch in the OFF position.
ALL accessories that do NOT use the accessory wiring
harness MUST be connected to the DC to DC
converter to pull from the full 48-Volt battery pack.
A DC to DC converter is necessary for the accessories
that need voltage different from 48 volts to operate
correctly.
Accessories, including a DC to DC converter, that are con-
nected to this vehicle and do not use the accessory wire har-
ness must be connected across the entire 48 volt battery pack.
To correctly connect a 48 volt accessory, connect one wire to
the most positive battery pack terminal and the second wire to
the most negative battery pack terminal as shown (Figure 2).
If an accessory requires voltage different than 48 volts a DC to DC converter must be used to change the voltage
to the correct amount. A DC to DC converter is available for purchase from E-Z-GO Service Parts.
The Operational Performance Guarantee of 2 rounds per day is void if non-factory accessories that use more
than 1 Amp/Hour of energy per round are installed on the vehicle.
Key Switch and Direction Selector
To decrease the risk of component damage, stop the vehicle before you move the key switch or the direction
selector.
To prevent the loss of control, do not move the direction selector while the vehicle is in motion. If
you move the selector, the vehicle speed will immediately decrease and a warning device
activates.
The key Switch and Direction Selector is located on the dash panel. The key switch or direction selector enables the
electrical system of the vehicle to be turned ON or OFF by turning the key. It also functions as the direction selector and
allows the operator to select F (forward) or R (reverse).
When the direction selector is moved to the R position, the reverse warning buzzer activates.
When the vehicle is without an operator, The key switch must be turned to the OFF position and removed, to prevent
accidental movement of the vehicle.
Attach Power Wire from
The Accessory to
(+) Battery Terminal
Attach Negative Wire from
The Accessory to
(-) Battery Terminal
Figure 2 Accessory Wires to Battery Pack
Attachment
