7
Revision Number-001 09-01-2019 - Present
EZG Manufacturing 1-800-417-9272 www.ezgmfg.com
PRE-START CHECKS
The following pre-start checks must be performed before the start of each work session or after every four
hours of use, whichever is first. Please refer to the Service and Maintenance section for detailed guidance.
If any fault is discovered, the Vibratory Forward Plate Compactor must not be used until the fault is rectified.
1.
Thoroughly inspect the machine for signs of damage, Make sure all guards are in place and secured.
Check for losse bolts and nuts, retighten if necessary.
2.
Check hoses, filler openings, drain plugs and other areas for signs of leakage. Fix any leaks before
operating.
3.
Check the engine oil level and top up as necessary. Use proper engine oil with the proper viscosity (SAE
10W-30 is recommended).
4.
Check the engine fuel level and top us as necessary. Use clean fuel. The use of contaminated fuel may
damage the fuel system.
5.
Check the air filter is clean. Excessive dirt/dust accumulation within the filter element will cause erratic
engine operation. Clean the air filter element when it is contaminated (refer to the Service and
Maintenance section).
6.
Check for fuel and oil leaks.
START/STOP PROCEDURE
Before starting the engine, make sure that the Safety Switch is in the ON position and the Throttle Lever is
set to the idle position.
1.
Take the Vibratory Forward Plate Compactor to where it is required. Use suitable lifting equipment to
position the Vibratory Forward Plate Compactor where it is necessary. Make sure the lifting equipment
has a WLL (Working Load Limit) suitable for the Vibratory Forward Plate Compactor weight. Attach
suitable slings or chains only to the lifting point.
2.
Never leave the engine running during transporting, even if it is for a short period of time.
3.
Having carried out the checks listed in the ‘pre-start’ section, you may start the engine. EZG
Vibratory Forward Plate Compactors are fitted with a centrifugal clutch which allows the engine to run at
idle speed without engaging the exciter and driving the Vibratory Forward Plate Compactor. The
Centrifugal clutch will be engaged as the speed of engine is increased. For correct operation, the engine
speed should be set to maximum, full-open position.
Before Starting Gasoline Engine
4.
Check the oil in the engine crankcase. Be sure to maintain the proper level per the engine manufacturer
specifications. If the oil is dirty and in need of changing, follow the Engine User Manual instructions.
5.
Check the fuel supply. Refer to Engine User Manual.
