1. DC IN port: 12V/1A power supply is required.
2. HDMI OUT port: Connect to the monitor for loopback.
3. HDMI IN port: Connect to your device (laptop or computer).
4. AUX IN port: Input audio to replace that from HDMI source.
5. IR OUT port: Output IR signal for remote control.
6. RJ45 port: Connect to router or switch with LAN cable for bridge. Only for
specific settings like firmware upgrade and CMS system control.
7. USB PC: Connect to your computer to receive reverse control signals.
8. RS232: Output RS232 signal for remote control.
9. Reset hole: Long press to reset to factory default settings.
10. PWR light: Lighting when power is supplied.
11. LINK light: Lighting when Ethernet is connected.
12. STA light: Flashing when data is transmitting.
15. Mode 2 light (Channel bit): Light on indicates channel adjustment is for
high-bit channel, while light off indicates channel adjustment is for low-bit
channel.
16. ID button: Click to switch channel ID, and long press to switch between
high-bit and low-bit channel adjustment (lighting for mode 2).
17. Channel signal: The channel number is the sum of what the light-on
signals represent.
18. Switch mode: Display the screen to WR01 with the same channel ID.
19. Splitter mode: Direct connection to WR01 for 1 to 1 extending display or 1
to N multicast. No channel ID should be set.
Hardware Installation for ER/ ET
1. Position the toggle switch to the same mode (SW/ SP) on both ER01 and
ET01.
2. Connect power to 12V/1A and a monitor to display output on ER01.
3. Connect power to 12V/1A, a monitor for loopback, and a device to input on
ET01.
4. Connect ER01 and ET01 to a switch with Ethernet cables.
5. For SW mode, please set ER01 and ET01 to the same channel ID. Every
ET01 under the same network should be set to different channel ID.
DC IN
HDMI OUT
RJ45
USB K/M
IR IN
AUX OUT
RS232
DC IN
HDMI OUT
HDMI IN
RJ45
USB PC
IR OUT
AUX IN
RS232
ER01
12V/1A
12V/1A
Power
Power
Monitor
Monitor
1
2
3
4
Device
ET01
SW
SP