EZ TANKLESS CampChamp, User Manual

Page: 14 / 20

14
Operation Method
Preparation before Ignition

Make sure the gas type used complies with what stipulated in the label.

Turn on the gas inlet valve.

Turn on the water valve (make sure there is water flowing out of the shower), and
then the water heater with “clicking” ignition sound. The burner is ignited and hot
water flows out instantly. If the water pressure is too low, or the power is not
connected, the water heater will not operate normally.

Check whether there is anything on the exhaust port. If yes, clean it.

After initial installation or change of gas cylinder, air may remain in the gas pipe
and it requires several ignition attempts to push the air out before the gas can be
ignited. If a problem comes up after normal operation, turn off the water
immediately. Try to re-ignite 10-20 seconds later to avoid blast burning.

Water Temperature Control
⑴
Turn the water temperature regulator knob to control the water flow and its
temperature. Turn the gas regulator knob to control the flame of the burner thus
controlling the hot water temperature. (Fig. 16)
The illustration is based on model with display and only for reference.
Fig.16 Fig.17
Gas control knob

Turn the gas control knob clockwise to increase the gas supply and anti-clockwise
to decrease the gas supply to main burner.
(2) Turn the water inlet knob to control the water temperature: decreasing the water
flow to make the water temperature higher (Please adjust it slowly, if the flame
extinguished then re-ignite before increasing the water flow), and increasing the water
flow to make the water temperature lower.

Turn off the hot-water outlet valve and the water heater will stop working
automatically, re-start hot water valve, heater will be re-ignite automatically and
start working.

Test water temperature with your hand before shower, so as to avoid
scalding.(Fig.17)

When the water pressure is too low, it’s suggest to turn the water flow control