11.
Twist both ends of tubes until fully secured.
12.
Place Center Support so the tubes rest in the slots
(
preferably thicker part of tubes
).
To make sure
Center Support contacts ALL Tubes - Push center support UP from Bottom. Then Mark Holes on Back Wall.
13.
Attach Center Support using anchors and screws
(see steps 4-5 on page 1).
Corner Installation – see “Using end Brackets” below
Extend one shelf all the way to the wall, and mount an end bracket next to the first shelf to begin your second shelf.
For longer walls see “Using end Brackets” below
Walls
in excess of 73” must join 2 units together using an end bracket. Two shelves can be attached to each other by
snapping a right Tube Bracket into one side of an End Bracket and a left Tube Bracket into the other side of the same End
Bracket and securing with included nuts/bolts.
Using End Brackets
End Brackets are used any time:
a.
Two units are joined together for longer units
b.
Two units meet at a corner
c.
Ending a unit without a sidewall (side of the closet)
1.
Snap Tube Receiver into appropriate side of End Bracket. Hold End Bracket up to wall to ensure that the
correct Tube Receiver is snapped in and the shelf will extend in the correct direction. If joining units
together, snap 1 tube receiver into each side of the End Bracket.
2.
Place Bolts into the outside of End Bracket. If joining two units together, it does not matter which way the
bolt is popped in.
3.
Thread nuts on the bolts and turn them a few times with your fingers. Tighten nuts & bolts with a manual
or electric screwdriver until snug.
4.
Measure from floor and tape the End Bracket template to the back wall. Check that shelf will be level and
mark holes with a pencil.
5.
Attach End Bracket to back wall with anchors and screws – see steps 4-5 for reference.
6.
Follow steps 4-13 on page 1 and page2
Note: DO NOT
rest Center
Support on
tube extension
sleeves.
