Auto-Sensing Mode (CCD) uses ambient light
to detect barcodes. The LED dims until a barcode
is presented to the scanner, then the LED brightens
to read the code.
If the ambient light condition is poor, the scanner
might not be working properly.
By default, the scanner will simply operate like
Trigger Mode which requires manual trigger.
To enable auto-sensing, place the scanner on an
Auto Hands-free Stand or disable Magnetic Switch
by scanning below configuration barcode.
GENERAL SETTINGS - READING MODE
GROUP-2
. F002$
TRIGGER MODE
. F007$
AUTO SENSING MODE (CCD)
The LED will light when the trigger is
pressed.
The LED will go off when the trigger is
released.
. F060$
The LED will turn on when the trigger is pressed.
The LED will turn off when the trigger is released.
Optimized to read bar codes from mobile phone
or other LED displays
MOBILE PHONE MODE
. F034$
MAGNETIC SWITCH OFF
. F035$
1. The Magnetic Switch is automatically activated when the scanner is in
Auto-Sensing Mode.
2. If Magnetic Switch is on, auto-sensing will be activated only when
the scanner is placed on an Auto Hands-free Stand.
3. If Magnetic Switch is off, the scanner will always be auto-sensing.
MAGNETIC SWITCH
NOTES:
MAGNETIC SWITCH ON
Summary of Contents for MT8200H
Page 1: ...Version 2018 1 Ez One Shot 2D HANDHELD SCANNER USER S MANUAL...
Page 39: ...F H A C V J Q S L N 0 GROUP 33 FULL ASCII TABLE CODE 39 SYMBOLS...
Page 40: ...B F J G Z I G I H L P R T W K M GROUP 34 DEL FULL ASCII TABLE CODE 39 SYMBOLS...
Page 45: ...FULL ASCII TABLE CODE 39 NUMBERS GROUP 39 0 1 2 3 4 5 6 7 8 9...
