Industrial POE Media Converter / Industrial POE Switch
Page 6 of 6
www.ez-net.co.kr
4.2 Wall-mounted installation
Pic 4
Pic 5
Pic 6
Fix hanging ears in the switch, as shown in figure 4;
Select 4 suitable screws (diameter of screw head should be less than 6
mm , diameter of screw should be less than3.5 mm diameter, as shown in Pic
5) and fix the device on the wall as Pic 6, don
’t completely tighten the screws,
keep some space about 2mm.
Install hanging ear of switch alignment inside the four screws, then press
the switch down, ensure the hanging ear has been fix properly, and turn the
screw.
4.3 Wall-mounted installation
Input terminal of the switch for 6PIN plug type
terminals, V1+ and V1- is for power supply 1 (PWR1), V2
+ and V2- is for power supply 2 (PWR2) and GND for
earthing terminal, as shown in Pic 7.
Power 1 and power 2 input voltage range is 12VDC ~
56VDC
，
V1+,and V2+ are positive, V1- and V2- are
negative, and the equipment supports anti reverse
function;
Two sets of power can be simultaneously accessed.
So if One of the power failure, the switch is still able to
work;
Pic 7
