EZ Lite Cruiser Regular, Manual

Page: 31 / 36

31
FAULT INDICATORS
Aside from indica ng the speed se ng of the EZ Lite Cruiser, the Speed
Indicator LEDs (number 8 on the fi gure shown on the previous page) acts
as an indicator of common faults in the controller system. When these
LEDs fl ash with the following Display as indicated below, the most com ‐
mon problems and their respec ve possible solu ons are iden fi ed:
Display Problem Solution
Ba ery power is low. You must recharge or replace the ba ery.
Joys ck cannot deliver signals to
the control module (CPU)
Check to see that all cable connec ons are
fi rmly a ached. If they are, this would indi ‐
cate a problem with the joys ck, and it may
need to be replaced with a working joys ck.
Joys ck wire could be cut.
An electronic drive locking func ‐
on is engaged to prevent the
EZ Lite Cruiser from being oper ‐
ated. Also acts to indicate that
the ba ery is being charged.
Disconnect the 3 ‐ pin Charger cable from the
front of the Joys ck component. If it is dis ‐
connected, this would indicate a problem
with the Joys ck’s Charger connector I/O
port.
Brushless motors fail to move. Check to see that all cable connec ons are
fi rmly a ached. If they are, this would indi ‐
cate an open or short circuit somewhere in
the controller system. Use a mul meter to
detect an open or short circuit.
Electromagne c lock on rear
wheels is disengaged.
Push the electromagne c levers on the rear
wheels back towards yourself (when stand ‐
ing behind the EZ Lite Cruiser) to engage the
electromagne c lock.