www.ezflofertilizing.com © 2013, EZ-FLO Fertilizing Systems
Installing your EZ-FLO:
Garden Hose & Drip Systems
Step 1:
Determine the type of installation that is
correct for your system (hose or drip) and insert the
correct FLO disc if necessary (see
“Flow
Requirements Section”
)
Step 2:
Install the
EZ-FLO
hose bib adapter in the
correct position as shown in the illustrations. The EZ
1010-HB may be installed before or after a timer. The
tank is capable of handling constant pressure.
Step 3:
Attach tubing to the hose bib adapter fitting.
Slide the Black tubing over the barb next to the blue
mark carefully to avoid stressing the fitting. Repeat
with the Clear tubing next to the Green mark.
Step 4:
Attach tubing to the green tank cap.
Do not remove the blue and green cap
connector nuts
.
Slightly loosen each nut and insert
the Black tubing through the center of the Blue nut
until it stops. Once it stops hand tighten the blue nut.
Repeat with the Clear tubing and the Green nut.
Additional Installation Notes:
If one is not already installed a hose vacuum breaker
must be installed to use an
EZ-FLO
system per local
plumbing codes
(not Included)
Back flow prevention
may not be required on well irrigation systems but is
still recommended.
When possible the hose bib adapter fitting should
always be the last component installed in any
configuration. Filters, & pressure regulators should not
be installed after the hose bib adapter.
The included tubing shut off valves may be used to
shut off the unit. These can be installed in the clear
and black tubing at any point. Tubing valves normally
drip under pressure, this will not affect the operation of
the EZ-FLO.
Unit includes 5 ft of clear and 5 ft of black tubing, you
may trim tubing to necessary length.
Garden Hose
Hose Bib
Adaptor
Garden
Hose -or-
Drip System
u
n
B
l
e
G
re
e
Hose
Bib
Vacuum
Breaker
Vacuum Breaker
Not Included
Completed
Installation
G
r
e
B
lu
e
en
Note: A Timer May Be
Installed Before Or After
The Ez-flo Hose Bib
Connector
(1010HB Only)
Page 2
