IN
Installation Supplement for PATHWAY® HD Step Adjustable Leg Kit
Page 5 of 5
1.7.
Using a 3/16″ Allen wrench and a 1/2″ socket or 1/2″ wrench, attach the
bracket (with leg installed)
to the riser side rail using 5/16”-18 x 2-1/2” button head socket cap screws, 5/16”-18 locknuts, and
5/16” flat washers oriented with cap screw and one washer on the riser side and the locknut and a
second washer on the bracket side (FIG. 1.3). Tighten fasteners securely.
1.8.
Loosen the bracket set screws just enough to allow the leg to contact the ground and support the
riser. Retighten set screws to 317 in.-lbs.
Do not lean, walk, or otherwise bear weight on the step until installation is complete.
1.9.
Repeat the process for the opposite side of the riser.
1.10.
Install 1-1/2” square tube plugs into the top of each leg. Use a rubber mallet or similar tool to fully
seat the plug if needed (FIG. 1.4).
1.11.
Complete all remaining steps in the main PATHWAY HD Code Compliant Modular Access System
Manual and the PATHWAY HD Step Supplement, as required for the system.
2.
FINAL CHECKS AND INSPECTION BEFORE USE
2.1.
Ensure all fasteners are in place and secure.
2.2.
Ensure that the level and slope has not shifted during installation.
2.3.
Remove any debris and metal chips.
2.4.
Walk on the assembled system, checking for any undue movement. If undue movement is
discovered, review the assembly process to ensure no processes were missed. If that does not
resolve the undue movement, do not use the system and call at 1-800-451-1903 for further
direction.
FIG. 1.3
FIG. 1.4
