EyeView Gpower-S3PIR, Hardware Installation Manual

Page: 10 / 27

2.2 Speed dome set up
Follow the description below setup IP speed dome’s hardware camera ID,
baud rate and protocol.
Speed dome setup
Video platform setup
AP (NVR2) setup
Camera ID, baud rate and protocol setting in these 3 item should be the same
for PTZ control function to work.
2.2.1 Setup camera ID, baud rate and protocol
Loosen the four screws and de-attached the dome cover from the housing.
Follow the tables below to setup each respective parameter. A 10-position
DIP SWITCH is furnished on the camera control board. SW1~ SW8 are for
ID address setting and SW9/SW10 are for protocol setting. Respective
setting is illustrated in the following table:
2-8
Address ID
Protocol/
Baud Rate
1 2 3 4 5 6 7 8 9 10
Setting of camera ID Address and
Communication Protocol