- 7 -
eyeheight
eyeheight
eyeheight
eyeheight
Unit 34 Park House Watford Business Park Greenhill Crescent Watford Herts GB WD18 8PH
Reg. No. 2855535 Telephone: +44 (0) 1923 256 000 Fax: +44 (0) 1923 256 100 email: [email protected]
2 Installation
Installation
Installation
Installation
2.1
2.1
2.1
2.1 Instal
Instal
Instal
Installation of the NS
lation of the NS
lation of the NS
lation of the NS----41 product
41 product
41 product
41 product
If this unit is already pre-installed in a flexiBox (FB-9), or a maxiBox, with either a
local or a remote panel from the factory then refer to the "Hardware Installation
Guide" which will be enclosed with the system. If this unit is pre-installed in a
miniBox (MB-9), then also refer to the "Hardware Installation Guide" which will be
enclosed with the system
If this unit has been ordered separately, we assume here that you already have a
flexiBox system with a Flexipanel and that the flexiBox has at least two spare
slots above each other for the NS-41 card.
2.2
2.2
2.2
2.2 Installing the NS
Installing the NS
Installing the NS
Installing the NS----41 into a flexiBox
41 into a flexiBox
41 into a flexiBox
41 into a flexiBox
To install the NS-41 into a flexiBox it is desirable (but not necessary) to power
down the flexiBox. Follow these instructions.
On the rear of the flexiBox are 6 slots for Products. Remove any pair of spare
blanking plates one above another. There are 2 off M2.5 Screws, which require
unfastening for each blanking plate.
Slide the Product PCB into the spare slots and firmly push it "home".
Use the two thumbscrews to fasten the unit in place. Take care that the ribbon
cable for the upper circuit board stays attached to the lower board.
Now refer to the "GeNETics User Guide". If your system consists of a single
flexiBox with a single flexiPanel then refer to the section titled "flexiPanel Auto
Set-up". If your system is part of a network with more than one flexiPanel then
refer to the section titled "flexiPanel Manual Set-up". This will guide you through
acquiring your product as a device on the flexiPanel.
2.3
2.3
2.3
2.3 Connecting to an NS
Connecting to an NS
Connecting to an NS
Connecting to an NS----41.
41.
41.
41.
Connections are simply four SDI inputs switched to one SDI output.
Figure 2-1 connections of an NS-41 module.