Exxentric kPulley2, Manual, Page: 17 / 24

17
kPulley2 Manual v2.5.0 kPulley Maintenance
3. Unwind all of the belt from the shaft and use the 3 mm hex key
to push the belt through the shaft and remove the lock pin.
4. Cut off the damaged belt. Harden the edge with a lighter.
5. Pull the belt through the shaft from the side with the narrower
groove. Fold the belt around lock pin and pull the belt and pin
into the wider groove in the shaft.
6. The belt automatically locks into the groove when you pull it
firmly. Make sure you can see the edge of the band when it’s in
place in the shaft (highlighted in third photo above).
7. Put the shaft cover back on and start training.
Note: If the lock pin is dropped inside the chassis, there is a spare
one in the tool kit. If both are lost, remove the chassis from the
beam and pick them up.
Replace the Drive Belt
Completely
Remove the belt from the shaft as above, pull it out
through the shaft and through the pulley block and the
sliding pulley. Untie the drive belt from the belt stop.
Re-attach the new drive belt in the belt stop and reverse the
procedure.