extronics iRFID101, Installation And Operating Manual

Page: 5 / 26

iRFID101 Installation and Operating Manual
5
2 Safety Information and Notes
2.1 Storage of this Manual
Keep this user manual safe and in the vicinity of the device. All persons required
to work on or with the device should be advised on where the manual is stored.
2.2 Special Conditions for Safe Use
2.2.1 ATEX/IECEx
1. Contact Extronics for information on the dimensions of the flameproof joints.
2. The RF output is only to be connected to an antenna suitable for the hazardous
location; refer to associated RF galvanic isolator iSOLATE501 equipment certificate
(IECEx TRC 15.0015X / TRAC15ATEX0050x) and associated instructions.
3. If the RF output connector is not intended to be connected to a cable and/or
antenna, the output connector must be capped.
2.3 List of Notes
The notes supplied in this chapter provide information on the following.
• Warning!
o
Possible hazard to life or health.
• Caution
o
Possible damage to property.
• Important
o
Possible damage to enclosure, device or associated equipment.
• Information
o
Notes on the optimum use of the device
Warning! Installation of the iRFID101 must be performed in accordance
with IEC 60079-14 and IEC 60079-25. Maintenance and
inspection must be performed in accordance with IEC 60079-
17.
Warning! Installation of the iRFID101 is only to be performed by skilled
electricians and instructed personnel in accordance with
national legislation.
Warning! The iRFID101 contains INTRINSICALLY SAFE circuits.
Warning! The iRFID101 Intrinsically Safe RF output ports are located in
the positions shown in Section 3.3. Only antennas in
accordance with Section 3.11 may be connected to these
ports. Refer to Section 3.12 for antenna installation
requirements.
Warning! The iRFID101 MUST be earthed. Refer to Section 3.4 for
earthing details.