Extron electronics XTP T USW 103, User Manual

Page: 14 / 46

XTP T USW 103 Switcher • Installation 6
D
XTP output connector — Connect a twisted pair cable to the RJ-45 connector
labeled
XTP OUT
on the XTP T USW 103 (see figure 2 ,
D
on page 4) and the XTP
input connector on another XTP device to pass all signals (see TP Cable Termination
and Recommendations on page 8). This cable carries the following signals:
•
Digital video
•
Digital audio
•
Bidirectional RS-232 and IR commands
•
Remote power
•
Ethernet communication
•
System communication
Signal LED indicator — Lights green when the XTP T USW 103
outputs a video signal or a test pattern.
Link LED indicator — Lights yellow when XTP devices are connected
and communication is established.
ATTENTION:
•
Do not connect this connector to a computer data or telecommunications
network.
• Ne connectez pas ce connecteur à un réseau de données informatiques ou à
un réseau de télécommunications.
• XTP remote power is intended for indoor use only. No part of the network that
uses XTP remote power should be routed outdoors (see
Remote power on
page 13).
• XTP à distance est destiné à une utilisation en intérieur seulement. Aucune
partie du réseau qui utilise l’alimentation XTP à distance ne peut être routée en
extérieur (voir
Remote power à la page 13).
E LAN connector — Connect a control device or device to be controlled to the RJ-45
connector labeled
LAN
(see figure 2 ,
E
on page 4) for 10/100Base-T Ethernet
communication through this pass-through port. LEDs on the connector indicate link and
activity status.
F RS-232 Over XTP port — To pass bidirectional serial signals between
XTP-compatible devices, connect a control device to the 5-pole captive
screw connector (see
figure 2 ,
F
on page 4). The port includes the
3 poles labeled “RS-232.”
IR Over XTP port — To transmit and receive IR signals (up to 56 kHz),
connect a control device to the 5-pole captive screw connector (see
figure 2 ,
F
on page 4). This port includes the 2 poles labeled “IR” and
shares the ground pole with the RS-232 port.
NOTE: RS-232 and IR data can be transmitted simultaneously (see RS-232 and IR
Over XTP Communication on page 10 for wiring details).
G
Contact closure connector — Connect an Extron KP 6 Keypad Remote Control or
similar device to the 3.5 mm, 4-pole captive screw connector (see figure 2 ,
G
on
page 4). The first three ports are used for selecting inputs 1 through 3 when
momentarily shorted to the ground port (see
Contact Closure Communication on
page 9 for wiring considerations).
Signal
Link
IR
Tx Rx G Tx Rx
RS-232
IR
Tx Rx G Tx Rx
RS-232