XTP FT HD 4K Fiber Transmitter • Installation
6
Transmitter XTP interconnection
D
RS-232 Over XTP connector
— To pass bidirectional serial or other control signals
between XTP-compatible devices, connect a control device to the 5-pole captive screw
connector. The connector includes only the two poles labeled “RS-232” and shares the
ground pole with the IR poles.
IR Over XTP connector
— To transmit and receive IR signals (up to 56 kHz), connect
a control device to the 5-pole captive screw connector. This port includes the two poles
labeled “IR” and shares the ground pole with the RS-232 poles.
NOTE:
RS-232 and IR data can be transmitted simultaneously (see
RS-232 and IR
Communication
on page 8 for wiring details).
E
XTP output connector
— Connect an XTP fiber receiver or matrix switcher to the XTP
fiber output connector.
WARNING:
Potential risk of severe injury.
The XTP FT HD 4K outputs
continuous invisible light, which may be harmful to the eyes; use with caution.
AVERTISSEMENT :
Risque potentiel de blessure grave ou de mort.
Le
XTP FT HD 4K émet une lumière invisible en continu qui peut être dangereux pour
les yeux, à utiliser avec précaution.
•
Do not look into the rear panel fiber optic cable connectors or into the fiber
optic cables themselves.
•
Ne regardez pas dans les connecteurs de câble fibre optique sur le panneau
arrière ou dans les câbles fibre optique eux-mêmes.
•
Plug the attached dust caps into the optical transceivers when the fiber cable is
unplugged.
•
Branchez les protections contre la poussière dans l’ensemble
émetteur/récepteur lorsque le câble fibre optique est débranché.
NOTE:
Ensure the proper fiber optic cable is used. Typically, singlemode fiber optic
cable has a yellow jacket and multimode fiber optic cable has an orange or aqua
jacket.
F
LAN connector
— Connect a control device or device to be controlled to the
pass-through LAN connector for 10/100Base-T Ethernet communication. LEDs on the
connector indicate link and activity status.
Transmitter power
G
Power connector and LED
— Connect the external 12 V, 1.5 A power supply to the
2-pole captive screw connector. For wiring considerations, see
Power Connection
on
page 8. The Power LED lights to indicate the device is receiving power.
