Extron electronics VNM EC 200, User Manual, Page: 25 / 242

6. Configure the IP address of the control PC so that it is within the address range of the
VNM EC 200.
NOTE: Complete this step only if the IP address of the VNM EC 200 is using
a
network prefix
other than
192
.
168
.
254
.xxx or
subnet mask
other than
255
.
255
.
255
.
0
.
7. If necessary, restart the control PC to save the configuration.
Setting the Role
Use the following procedure to set the role of the VNM EC 200. See Accessing the
Web‑based User Interface on page 11 for login information.
1.
Click the Configuration tab. The Configuration page opens (see figure 12,
1
).
1 1
2 2
3 3
4 4
Figure 12. Configuration Page — Single VNM EC 200 Role Setting
2. Click the Role link (
2
).
3. From the
Device Mode
drop-down list, select
singleton
(
3
).
NOTE: For information on the other device modes, see Role Page on page 22.
4. Click Apply Changes (
4
).
NOTE: The Web-based user interface returns to the login page after saving the
configuration.
VNM EC 200 • Single EC 200 Configuration 15