Extron electronics UPB 125 Installation Manual Download Page 2

 

UPB 125 • Installation Guide (Continued)

2

Pipe Adapter
Block

Base Plate
Assembly

Arm Locking

Screw and

Washer

Barrel

Arm

Projector

Mounting

Screw

Loosen the thumbscrew and slide
the Pipe Adapter Block 

A

 

away

from the Base Plate Assembly 

B

.

A

B

D

C

Pivot arms towards center of the projector.

ATTENTION:

Center the Arm Barrel
on the mounting point.

Mounting Point on the Projector Base

Insert and tighten down
an appropriate sized screw.

Installing the UPB 125

Preparation

Separate the two main parts (Pipe Adapter Block 

A

 

and Base 

Plate Assembly

 

B

) of the UPB 125 (see the figure at right).

Installing the Base Plate Assembly on the Projector 

1. 

Invert the projector on a protected surface to access the 
mounting points. 

2. 

At the end of the arm 

C

,

 rotate the barrel 

so that it 

protrudes from the base of the arm about 1/4 inch.

3. 

Select the correct sized projector mounting screws 

D

 

that fit the projector mounting point inserts. 
 
 
 

4. 

Attach the arms to the projector (see the figure at right). 
 

5. 

Pivot the arms so that they extend towards the center of the  
projector (see the figure at right). 

It is critical to provide evenly level arms at each mounting 
point for the Base Plate Assembly to secure to.

ATTENTION:

 

• 

Do not overlap the arms.

• 

Ne pas superposer les pattes de montage.

6. 

With the arrow on the Base Plate Assembly pointing towards the front 
of the projector, place the Base Plate Assembly on top of the arms  
and adjust for slot alignment with the holes in the arms. 

7. 

Loosely secure each arm to the base plate (see the figure at right). 

8. 

As close as possible, balance the weight of the projector evenly 
across the Base Plate Assembly. Adjust the Plate on the arms as needed.

ATTENTION:

 

• 

Distribute the projector weight evenly on the arms.

• 

Répartissez le poids du projecteur de façon égale sur les 
pattes.

Lift the assembly at opposite corners to assess if the configuration 
is approximately balanced.

Align a screw hole with a slot
in the Base Plate Assembly. 
Then place washer, insert the screw,
and tighten down the screw.

Reviews: