Extron electronics Two InpuT VIdeo Scaler IN1502, User Manual, Page: 42 / 44

Appendix, cont’d
IN1502 • Appendix A-6
5. After you are electrically grounded, you can remove the U17 IC chip or U38
IC chip by grasping it firmly with your fingers and pulling it out; then
continue to step 8.
Removal of the U41 IC chip requires a PLCC IC puller
tool. To remove the U41 chip, align the hooks of a
PLCC IC puller tool with the slots located in opposite
ends of the U41 firmware chip.
6.
Insert the hooks into the slots, and squeeze the tool
gently to grasp the chip.
7. Pull the chip straight out of the socket, and set it aside.
8. For U17 and U38, align the notch of the new firmware
chip with the notch of the socket in the same
orientation as the old chip.
For U41, align the angled
corner of the firmware
chip with the angled
corner of the socket.
9. Gently, but firmly, press
the chip into place in the
socket.
10. Replace the top cover on the IN1502 scaler, and fasten
it with the screws that were removed in step 3.
11. Rack or furniture mount the scaler, and reconnect the AC power cord.
U41
Align Notche s
U41
U38
U17