Reset All IP Settings
This mode resets all IP settings to factory defaults.
Activation
To reset all IP settings:
1.
Hold down the
Reset
button for about 6 seconds until the Power LED blinks twice (once at
3 seconds and again at 6 seconds).
2.
Release and press
Reset
momentarily (for <1 second) within 1 second. Nothing happens if
the momentary press does not occur within 1 second.
Result
Reset All IP Settings mode:
•
Sets the IP address back to factory default (192.168.254.251).
•
Sets the subnet back to factory default (255.255.255.0).
•
Sets the default gateway address to the factory default (0.0.0.0).
•
Sets all other IP settings, addresses, and domain and host names back to factory default.
•
Turns DHCP off.
Reset to Factory Defaults
This mode resets all IP settings and touchpanel settings to factory defaults and removes all
configurations. It allows you to start over with configuration and uploading.
NOTE:
The factory configured passwords for all accounts on this device have been set
to the device serial number. If the device is reset to factory defaults, the passwords
revert to
extron
. Passwords are case sensitive.
Activation
To reset the unit to all factory default settings:
1.
Hold down the
Reset
button for about 9 seconds until the Power LED blinks three times
(once at 3 seconds, again at 6 seconds, and again at 9 seconds).
2.
Release and press
Reset
momentarily (for <1 second) within 1 second. Nothing happens if
the momentary press does not occur within 1 second.
Result
Reset to Factory Defaults mode performs a complete reset to factory defaults (except firmware):
•
Does everything Reset All IP Settings mode does.
•
Removes touchpanel user interface layout and configurations.
•
Resets all touchpanel settings to factory default.
TLP Pro 525C and 725C Series Touchpanels • Reference Material
38
