Mounting to Drywall
If the wall box is not required by local building codes, you can mount the TLC Pro 526M,
726M, or 1026M directly into drywall.
1.
Go to
and download the cut‑out template for your TLC model. Print the
template at 100% size (no scaling).
2.
Remove the gray area in the center of the template, place the template against the wall or
furniture in a suitable location, and ensure that it is level. Use the template to mark the hole
that is being cut and the location of the MK/Wall slots (see
NOTE:
The mounting plate for the TLC Pro 526M has four holes marked Wall for
mounting to drywall. The mounting plate for the TLC Pro 726M and TLC Pro 1026M
has two holes that double for mounting to drywall and MK junction boxes.
3.
Cut a hole in the wall or furniture (see
, on the previous page).
4.
Drill two pilot holes at the location of the MK/Wall slots.
5.
Secure the mounting plate to the wall. Extron recommends using two molly bolts or
SnapToggle bolts.
6.
Complete the installation as described in
of the previous section.
NOTE:
Extron provides four 3/4" #6‑32 Philips pan head screws for mounting to US
junction boxes and two 16 mm M 3.5 Philips pan head screws for mounting to MK
junction boxes. Screws are usually provided with EU junction boxes.
Mounting with Optional Kits
A number of kits are available for mounting these TouchLink Pro control systems (see
). The kits must be purchased separately and installed by following the
instructions provided with the kit.
note
TLC Pro 526M, 726M, and 1026M Series TouchLink Pro Control Systems • Mounting
32
