Figure 32 shows how to mount the TLC Pro 726M. Mounting the TLC Pro 526M or 1026M is
very similar.
TOP
e
Back View
1
2
3
4
5
6
4
Figure 32.
Mounting the TLC Pro 726M to a Wall Box
1.
Install a junction box or wall box (see figure 31,
1
), following the instructions provided by
the manufacturer.
NOTE:
If you are mounting a TLC Pro 526M, the US 1‑gang junction box should be
installed so that the long side is horizontal.
2.
Make sure you have the correct mounting plate for your TLC and fasten it to the wall with the
provided screws (
2
). Use the mounting holes that are appropriate to the junction box you
are using (see
, on the previous page).
NOTES:
•
Extron provides four 3/4" #6‑32 Philips pan head screws for mounting to US
junction boxes.
•
Extron provides two 16 mm M 3.5 Philips pan head screws for mounting to MK
junction boxes.
•
EU junction boxes usually provide their own screws.
3.
Run and connect cables to the back of the TLC (see
4.
Position the touch panel so that the mounting slots in the rear of the TLC align with the
hooks on the mounting plate. The TLC Pro 726M and 1026M mounting plate has four
hooks (
3
), one in each corner, top and bottom. The TLC Pro 526M mounting plate has two
hooks, one in each corner at the top.
5.
Move the TLC inwards so that slots move over the hooks.
6.
Move the TLC down so that it is seated securely on the hooks, and the tongue at the bottom
of the mounting plate (
4
) is sitting in a groove in the bottom of the TLC (see inset,
5
).
7.
Tighten the mounting screw (
6
) to fasten the TLC to the mounting plate.
figure 32
steps 3 through 7
TLC Pro 526M, 726M, and 1026M Series TouchLink Pro Control Systems • Mounting
31
