1
Product Category
:
Go to
complete user guide and installation
instructions befor
e connecting the
product to the power sour
ce.
TLP Pro 1220TG, TLP Pro 1520TG,
and TLP Pro 1720TG • Setup Guide
Overview
The Extron TLP Pro 1220TG, TLP Pro 1520TG, and TLP Pro 1720TG are table-top touchpanels with high resolution capacitive
touch screens. The TLP Pro 1220TG has a 12.1 inch screen with a 1280x800 resolution. The TLP Pro 1520TG has a 15.6 inch
screen with a 1366x768 resolution. The TLP Pro 1720TG has a 17.3 inch screen with a 1920x1080 resolution. They are ideal for any
AV applications requiring large touchpanels with flexible mounting options and fully customizable interfaces. This guide provides
instructions for experienced installers to mount and install these touchpanels. For more complete procedures, see the
TLP Pro 1220,
TLP Pro 1520, and TLP Pro 1720 Series User Guide
.
Setup Overview and Checklist
Get Ready
Download and install the latest version of the following software:
z
GUI Designer
— for designing layouts for Extron TouchLink
®
Pro touchpanels and third party touch interfaces.
z
Global Configurator
®
Plus and Professional
— for setting up and configuring the control processor and touchpanel.
z
Toolbelt
— for device discovery, device information, firmware updates, and configuration of network settings, system
utilities, and user management for TouchLink Pro devices.
All three software programs are available from
.
Obtain the following network information from your network administrator:
DHCP status (on or off). If DHCP is off, you also require:
IP address
Subnet mask
Gateway
User name — this can be either
admin
or
user
.
Passwords — by default, these are
extron
(for both admin and user).
Make a note of the touchpanel MAC address.
Mount and Cable All Devices
ATTENTION:
•
Do not power on the touchpanels or control processors until you have read the Attention in the Power Supply section of
the
TLP Pro 1220, TLP Pro 1520, and TLP Pro 1720 Series User Guide
or the
IPL Pro User Guide
.
•
Ne branchez pas les écrans tactiles ou les contrôleurs avant d’avoir lu la mise en garde dans la section « sources
d’alimentation » du
TLP Pro 1220, TLP Pro 1520, and TLP Pro 1720 Series User Guide
ou du
IPL Pro User Guide
.
Mount the units. There are several mounting options for TouchLink Pro touchpanels (see
on the following page).
Connect cables to the touchpanels. To connect cables, remove the back and base covers (see
on the following page).
For more information about the cable connectors, see
on page 4.
Connect the power cords and power on all devices.
Set up the Touchpanels for Network Communication
Connect the PC that you will use for setup, the control processor, and touchpanel
to the same Ethernet subnetwork
.
Use the
(see page 5) or Toolbelt to set the DHCP status and, if necessary, the IP address, subnet mask, gateway,
and related settings for the touchpanel.
Configure the Touchpanels
The
GUI Designer Help File
,
Global Configurator Help File
, and the
Toolbelt Help File
provide step-by-step instructions and more
detailed information. The
Global Configurator Help File
includes an introduction to the software and sections on how to start a
project and configuration.