Extron electronics TLP Pro 1025 Series, User Manual

Page: 24 / 48

On-screen Menus
On‑screen menus allow initial configuration of the touchpanels. The figures in this section show
screens for the TLP Pro 525M. Unless stated otherwise, the screens for the other touchpanels
are very similar.
Setup Menu
To open the setup menu, use a screw driver with a fine blade to press the Menu button. The
Menu button is located on the rear panel of the TLP Pro 525M, 725M, or 1025M (see figure 3 ,
A
, on page 8) or on the base of the TLP Pro 525T, 725T, or 1025T (see figure 4 ,
A
, on
page 11).
The menus open at the
Status
screen. There are five different screens:
•
Status (see below)
•
Audio (see page 18)
•
Network (see page 15)
•
Advanced (see page 19)
•
Display (see page 17)
These can be selected by pressing the appropriate button in the navigation panel at the top of
the screen. The button for the selected screen is yellow. The buttons for the remaining screens
are black.
There is also a red
Exit button in the top right corner of the screen. Pressing this button applies
and saves any changes and closes the menu screens.
Status
Press the
Status
button in the navigation panel at the top of any screen to open the
Status
screen.
Status
Display Audio Advanced Exit
Network
Info
Model: TLP Pro 525M
Part Number: 60-1561-02
Firmware
Version: 1.00.0001-b003
Network
IP Address:
DHCP:
Host Name:
Off
192.168.254.251
TLP-AB-CD-EF
Display
Resolution:
GUI Project:
Sleep Timer: 800x480
N/A
5 Minutes
Audio
System Volume:
System Mute:
Off
99
Advanced
Controller IP: N/A
Project Size: N/A
Bootloader
Version: 1.00.0000
Figure 6. Status Screen
The
Status
screen is a read‑only screen that provides basic information about the touchpanel.
Each of the other four panels shows a summary of the information on the other screens.
Pressing any of the panels opens the corresponding screen in exactly the same way as pressing
the buttons in the top navigation panel.
A green bubble in the
Network
panel lights when there is a network connection or a red square
appears if there is no connection. The green bubble in the
Advanced
panel lights when a control
processor is connected or a red square appears if none is connected.
TLP Pro 525, 725, and 1025 Series Touchpanels • On-screen Menus 14