Installation, cont’d
SW RGB and YUV A Switchers • Installation
2-4
Under furniture mounting the switcher
The SW2 switcher models can be mounted under a table or other horizontal surface
with an optional Extron under-desk mounting kit (part #70-077-01). The SW4 and
SW6 switcher models can be mounted under a table or other horizontal surface
with an optional Extron 1U under-desk mounting kit (part #70-222-01).
SW2 models
1
.
Secure the optional under-desk mounting brackets to the switcher with the six
machine screws provided in the mounting kit (figure 2-3).
2
.
Hold the switcher with attached brackets against the underside of the desk or
other furniture. Mark the location of holes for screws on the desk.
Under Desk Kit
SW
2 R
GB
HV
RGBHV & A
UDIO SW
ITCH
ER
AU
TO
SW
ICH
AC
UT
IVE
2
1
Figure 2-3 — Under-desk mounting
3
.
Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or
desk at the marked screw locations from the underside/inside (concealed
side) of the furniture, where the switcher will be located.
4
.
Insert the four wood screws into the pilot holes. Fasten each screw into the
installation surface until just less than 1/4" of the screw head protrudes.
5
.
Align the installed screws with the slots in the mounting brackets, and place
the switcher against the surface, with the screws through the bracket slots.
6
.
Slide the switcher slightly forward or back, then tighten all four screws to
fasten it in place.
SW4 and SW6 models
1
.
Secure the optional table/wall mounting brackets to the switcher with the
eight machine screws provided in the mounting kit (figure 2-2).
2
.
Hold the switcher with attached brackets against the underside of the desk or
other furniture. Mark the location of holes for screws on the underside of the
desk.
