1
:
Go to
for th
e
complete user guide and installation
instructions befor
e connecting the
product to the power sou
rce.
SMK V SB 33 Plus VESA Mounting Kit • Installation Guide
The SMK V SB 33 Plus VESA Mounting Kit allows the SB 33 Series of soundbar speakers to be attached to the same VESA
mount supporting the display device. The SB 33 speaker front surface can be adjusted flush with the front of the display. It can
be adjusted forward, backward, up, down, and side-to-side.
Installation
VESA display mounts come in a variety of different styles, so installation may vary. Please consult the installation guides for your
specific VESA display mount and your display device before installing the SMK V SB 33 Plus VESA mounting kit. Follow the steps
below to install the kit.
WARNING:
Risk of personal injury or property damage
.
The final installation should be able to continuously support
the speaker weight. The final installation should also be able to support short term overloading. Be sure to not exceed the
load limit of the VESA mount, mounting surface, and SMK V SB 33 Plus. The maximum load limit of the SMK V SB 33 Plus
is 85 lb (38 kg). Since applications can vary considerably, it is assumed that the installer will exercise good judgment when
selecting the mounting location, method, and hardware. Installation and service must be performed by authorized personnel
only.
AVERTISSEMENT:
Risque de dommages corporels ou matériels.
L’installation finale doit pouvoir supporter en
permanence le poids de l’enceinte. L’installation finale doit également pouvoir supporter une courte surcharge. Veillez à ne
pas dépasser la charge maximale du support de montage VESA, de la surface de montage, et de l’unité SMK V SB 33 Plus.
La charge maximale du SMK V SB 33 Plus est de 38 kg. Étant donné la possibilité d’évolution considérable des applications,
il est supposé que l’installateur fera preuve de discernement lors de la sélection de l’emplacement, du mode, et du matériel
de montage. L’installation et la maintenance du système doivent être exclusivement effectuées par un technicien agréé.
NOTE:
Observe all applicable building codes and local ordinances when installing a soundbar speaker.
The SMK V SB 33 Plus VESA mounting kit is composed of 2 long L-brackets, 2 short L-brackets, 4 metal washers/spacers,
4 plastic spacers, 6 bolts, 6 lock washers, and 6 wingnuts.
1.
Install the wall mount portion of the VESA display mount onto the desired wall location.
2.
Position one long L-bracket of the SMK V SB 33 Plus kit on the back of the display, while aligning the bottom bolt hole on the
display with a round hole on the L-bracket and the top bolt hole with one of the slotted holes.
NOTE:
The L-bend of the long bracket should align with the bottom of the display device.
Repeat this procedure for the other long L-bracket on the other side of the display. Use the included plastic spacers if any
portion of the display back panel protrudes further than the VESA mounting points and prevents the brackets from being
seated properly.
Long L-brackets
Plastic
Spacer
Figure 1.
Installing Long L-Brackets
NOTE:
The long L-brackets are designed to accomodate a variety of display heights. If the bracket is exposed over the
top of the display, the top 8
″
(203 mm) of the SMK V SB 33 Plus long L-bracket can be broken off. To do this, simply
bend the top breakaway portion back at the seam until it breaks off. (see figures 1 and 2 for details).
