Extron electronics SMA-2, Installation Manual

Page: 2 / 2

2
68-2831-51 Rev. A
04 17
Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron USA - West Extron USA - East
+1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX
+1.919.850.1001 FAX
Extron Europe
+800.3987.6673
(Inside Europe Only)
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.299.1800
+971.4.299.1880 FAX
Extron Australia
+61.8.8113.6800
+61.8.8351.2511 FAX
Extron India
1800.3070.3777
(Inside India Only)
+91.80.3055.3777
+91.80.3055.3737 FAX
© 2017 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
www.extron.com
SMA 2 • Installation Guide (Continued)
Step Three — Secure the Touchpanel Mounting Plate to the Touchpanel
1.
Before securing the mounting plate to the touchpanel, ensure the
CATx cable is inserted into the LAN/PoE connector on the base of
the touchpanel (see figure 3,
1
).
You may need to remove the cover to get access to the LAN/PoE
connector, which is in the side wall of the recessed area.
2.
If a cable is pre-installed in the touchpanel, remove it from the
cable guide at the back of the touchpanel base and reroute it
through the threaded barrel of the mounting plate.
3.
Use the two provided #6-32 flat head screws (
2
) to secure the
mounting plate to mounting holes in the base of the touchpanel.
1 1
2 2
Figure 3.
Secure the Touchpanel Mounting Plate
Step Four — Complete the Installation
1.
Insert the threaded barrel of the mounting plate through
the hole in the table and through the base plate (see
figure 4,
1
).
2.
From under the table, thread the network cable through
the components of the kit, in the following order:
a.
Frictionless disk
b.
Swivel disk
c.
Lock nut
3.
Insert the frictionless disk (
2
) into the base plate.
4.
Place the swivel disk ( 3 ) over the frictionless disk.
Ensure that the tooth is correctly placed between the
set screws.
5.
Secure the assembly with the lock nut ( 4 ). Ensure
that the nut is in the correct orientation so that the
sharpened tangs grip the swivel disk.
Do not overtighten : the assembly must be free to
rotate.
4
3
2
1
Figure 4.
Complete the Installation