e.
Use a small screwdriver to pry and separate the insert from the locking arm, as
shown below
.
Figure 35.
Prying off the locking arm insert
f.
Repeat this process for the remaining two locking arms.
g.
Rotate all three locking arms back into the speaker.
7.
Configure the cable conduit access plate and captive screw connector
.
a.
If two conduits are being used
, knock out the alternate knockout.
i.
Place the head of the screw driver on the notch of the knockout.
ii.
Tap the back of the screwdriver until the knockout pops out.
b.
Loosen the two side cable conduit access plate screws and remove the plate
before wiring the speaker.
Alternate
Knockout
Cable/conduit
access plate
Screws (2)
Cable
clamp
Figure 36.
Removing the Cable Conduit Access Plate
SF 3C LP and SF 3CT LP User Guide • Installation
32
Summary of Contents for SF 3C LP
Page 2: ......