SF 10C SUB • Installation
11
The subwoofer can be set vertically on a floor using the optional SMK F SF 10C Plus floor
mounting kit, as follows:
1.
Determine where the subwoofer is to be placed and its orientation (port tube on top or
port tube on the bottom).
NOTES:
•
Remember that the sound from the unit is directed out the port. Therefore, the
port needs to be pointed into the listening space.
•
To ensure that the Extron grille fits fully into any masking wall or other partition,
the center of the port tube must be at least 5-3/16 inches (13.7 cm) from the
edge of the wall.
•
The grille does not fit if you install the legs on the subwoofer with the port tube
down. Consider fabricating a small platform to lift the subwoofer or otherwise
design your own way to dress the installation to give your installation a finished
look.
•
Steps 4, 5, 6, and 9 are only necessary if you are installing the subwoofer in an
adjoining space.
2.
Remove the grommets from the holes in the installation bracket.
3.
Fasten two legs to each installation bracket using the provided screws and locking nuts,
two on one side of the foot (see figure 5,
1
), and one on the other side (
2
).
1
1
1
2
2
2
2
2
2
1
1
1
Figure 5.
Installing a Floor Mounting Kit
4.
When installing in an adjoining space
—
On the far side of the wall
(
outside
the
listening space), remove enough wall material so that the subwoofer port tube can be
placed as close to the wall (facing the listening space) as possible.
5.
When installing in an adjoining space
—
On the near side of the wall
(
inside
the
listening space), using the included grille cut-out template, mark where the center of the
port tube faces the installation surface. The center mark must be at least 5-3/16 inches
(13.2 cm) from the edge of the installation surface (see
on page 7) if the
grille will be used (see
6.
When installing in an adjoining space
—
On the near side of the wall
(
inside
the
listening space), mark and cut the hole in the surface.
7.
Place the subwoofer in the desired location.
5
