b.
Adjust the SB 33 to the desired distance from the display and then tighten the
bolts.
CAUTION:
If the display is already attached to the wall, the display could
detach from the VESA mount if this adjustment is made. It is highly
recommended that this adjustment be done prior to attaching the display to
the wall.
ATTENTION:
Si l’écran est déjà fixé au mur, il peut être détaché du support
de montage VESA si ce réglage est effectué. Il est vivement recommandé
d’effectuer ce réglage avant de fixer l’écran au mur.
NOTE:
Assuming the display screen
is level, allow for some space
between the bottom of the display
screen and the top of the speaker
because the speaker assemblies
and the center bracket attach to
the wall plate by hooking the top
mounting clasps of the speaker
assemblies and center bracket
over the top mounting rail of the
wall plate.
To allow sufficient clearance
between the top of the
SB 33 A and the display screen
above it, allow for at least a
minimum clearance of 11/16 inch
(17.5 mm) between the highest
part of the top rail of the wall plate
and the top of the speaker, as
shown to the right. The display
screen should not encroach into
this area above the top rail.
The long L-brackets for the SMK V SB 33 Plus have holes for the lower
VESA holes. As a result, it may be necessary to remove the lower bolts
in order to adjust the vertical height. Depending on the short L-bracket
orientation and depth adjustment, it is also possible to adjust the SB 33
speaker height by adjusting the wall bracket position on the short L-bracket.
12.
Install the SB 33 A speaker to the wall plate as shown in figure 37.
Wallplate
Side View
11/16"
(17.46 mm)
Short L-bracket
Long L-bracket
Display
SB 33 A Series • Installation
25
