3
Product Category
Installation
ATTENTION:
•
Installation and service must be performed by authorized personnel only.
•
L’installation et l’entretien doivent être effectués par le personnel autorisé uniquement.
•
If the RCP 101 will be installed into fine furniture, it is best to hire a licenced, bonded craftsperson to cut the access
hole and perform the physical installation so the surface will not be damaged.
•
S’il est prévu d’installer le RCP 101 dans du beau mobilier, il est préférable de faire appel à un artisan autorisé et
qualifié pour couper le trou d’accès et réaliser l’installation de telle façon que la surface ne soit pas endommagée.
•
Follow all national and local building and electrical codes that apply to the installation site.
•
Respectez tous les codes électriques et du bâtiment, nationaux et locaux, qui s’appliquent au site de l’installation.
•
All electrical installation should be performed by qualified personnel in accordance with local and national building
codes, fire and safety codes, and local and national electrical codes.
•
Toute installation électrique devrait être effectuée par un personnel qualifié, conformément aux codes du bâtiment,
aux codes incendie et sécurité, et aux codes électriques locaux et nationaux.
Step 1: Prepare the Installation Site
Americans with Disabilities Act (ADA) compliance
When planning where to install these devices, you may need to consider factors affecting accessibility of the button panel such
as height from the floor, distance from obstructions, and how far a user must reach to press the buttons. For guidelines, see
sections 307 (“Protruding Objects”) and 308 (“Reach Ranges”) of the
2010 ADA Standards for Accessible Design
available at
http://www.ada.gov/regs2010/2010ADAStandards/2010ADAStandards.pdf
.
Site preparation
The RCP 101 EU f
its the opening in a 1-gang EU, Jung AS 500 wallplate, Extron Flex55 mounting system, or other European frame
that accepts 55 mm x 55 mm modules
. The RCP 101 MK fits
in a standard MK wall frame for United Kingdom junction boxes
.
The units are shipped with a metal bracket and metal spacer that enable them to be mounted in the appropriate junction box.
Extron offers optional UL Listed in-wall junction boxes, external wall boxes (EWBs), and surface or tabletop mounting boxes (see
www.extron.com
). To use these optional mounting accessories, follow the instructions provided with the mounting kit.
Step 2: Cable All Devices
Run the power and USB cables to the required destination but do not connect them until you have mounted the unit.
ATTENTION:
•
Do not connect a power supply before reading the Attention notifications in the “Power connector” section on
page 2
.
•
Ne branchez pas une source d’alimentation externe avant d’avoir lu les mises en garde dans la section
« Power connector » sur
page 2
.