Extron electronics Quantum Ultra Series, User Manual

Page: 67 / 125

Quantum Ultra Series Videowall Processing Systems • Operation 59
2. If desired, enter a name of 1 to 15 characters for your Quantum Ultra Series
processor in the
Device Name field (see figure 60 ,
1
on the previous page). Only
letters, numbers, and the hyphen ( - ) can be used in this name.
NOTES:
• The device name must start with a letter.
•
All letters in the Device Name field are displayed in uppercase. By default the
device name is QU610- followed by the last three hex pairs of MAC address.
3. Select the tab for the LAN port to configure ( LAN A or LAN B ) (
2
).
4. Select the Use DHCP checkbox (
3
) to automatically assign all IP addresses, or
Enter the addresses in the IP Address , Subnet Mask , Default Gateway , and DNS
Server fields (
4
).
NOTE: The Media Access Code (MAC) address cannot be changed.
5. If desired, select the tab for the other LAN port and repeat step 4.
6. When finished, click Confirm (
5
). A message window opens, notifying you that the
unit will restart in 5 seconds.
7. Click OK on the prompt to close it. The unit restarts, applying your new settings.
Resetting the Device from the Control Panel
To reset the Quantum Ultra unit (see figure 61):
1. Click the Reset Device button on the Control Panel (see figure 47 ,
5
on
page 51).
Figure 61. Reset Device Window
61