NOTES:
The length of exposed wires is critical. The ideal length is 3/16 inch (5 mm).
If the stripped section of wire is longer than 3/16 inch, the exposed wires may
touch, causing a short circuit. If it is shorter than 3/16 inch, wires can be easily
pulled out of the captive screw connectors.
Figure 5 identifies the tip, ring, and sleeve parts of standard audio connectors. A mono
audio connector consists of the tip and sleeve. A stereo audio connector consists of the tip,
ring and sleeve. The tip, ring, and sleeve wires are also shown on the captive screw audio
connector diagrams.
Tip (+)
Sleeve ( )
Sleeve ( )
Ring (-)
Tip (+)
RCA Connector
3.5 mm Stereo Plug Connector
(balanced)
Figure 5.
Typical Audio Connectors
c
RJ-45 connector —
MTP T AV board —
Connect the transmitter to a
suitable MTP receiver via this connector. Terminate
the cable as shown on the right, using the same
standard (A or B) at both ends
MTP R AV board —
Connect the twisted pair
cable from the transmitter to this input connector.
Terminate the cable as shown on the right, using
the same standard (A or B) at both ends
d
Power LED —
This LED lights to indicate that
power is applied to the board.
e
Sharpness and Gain Adjustment (MTP R AV only) —
Image sharpness and gain can
be adjusted with these two potentiometers for optimizing the image and signal quality.
View the image and adjust the either control for the best image quality.
5
Pin
1
2
3
6
7
8
4
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Wire color
T568A
T568B
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
Blue
Blue
Insert Twisted
Pair Wires
Pins:
12345678
RJ-45
Connector
PowerCage MTP T AV and PowerCage MTP R AV • Installation and Operation
5
