PowerCage FOX HDMI • Remote Control
27
Starting the Program
Start the Extron FOX Extenders program as follows:
1.
Click
Start
>
Programs
>
Extron
Electronics
>
FOX Extenders
Control Program
>
FOX
Extenders
.
The Communication Setup window appears (see figure 15).
Figure 15.
Communication Setup Window
2.
Select the Com port to which your transmitter or receiver is connected. Click
OK
. The
FOX Extenders Control Program window appears (see figure 16).
Figure 16.
FOX Extenders Control Program Window
NOTES:
•
Figure 16 is an amalgam of program displays. Some controls and displays are
available when connected to the transmitter
only
and some when connected
to the receiver
only
. These functions are identified in the descriptions that
follow.
•
Only one fiber optic cable, transmitter-Tx-to-receiver-Rx, is required for
serial command transmission. But, if you connect only one fiber optic cable,
the transmitter does not receive reports from the controlled device. For the
transmitter to receive responses from the controlled device, you must install
two fiber optic cables and leave link 2 enabled (via an
to the
receiver or using the
Summary of Contents for PowerCage FOX Rx HDMI
Page 6: ......