Extron electronics Matrix 3200 Series, User Manual

Page: 53 / 70

5-11 Matrix 3200/6400 Series • Upgrades and Troubleshooting
change the gain for output 51, pull the card for outputs 49-56, count from the top
header pair which is for output 49. The target headers are H13 and H14; swapping
their jumper positions will change the gain for output 51.
Gain jumpers must be changed in pairs (H9 & H10 through H23 & H24).
Do NOT change the position of the jumpers on headers 25 and 26 (H25 &
H26).
Adding BME(s) to a Matrix 3200/6400 System
Adding BME(s) to an existing Matrix 3200/6400 System involves doing most of the
same steps as an initial installation. Extron recommends that the following steps be
done in the order listed to add an Audio BME to an existing system.
1. See Page 5-12 “Software Procedure - Before
and After a Hardware Upgrade”. Do steps
under “Before Hardware Changes” before
making any hardware changes.
To ignore step 1 and proceed with the
hardware upgrade will require
considerable system reconfiguration time.
It is highly recommended that you not skip
any step.
2. Remove power before proceeding. Go to
“Adding a Matrix 6400 Audio BME” (see
Page 5-10 below). If this is not an Audio BME
add-on, go to Chapter 2.
3. Set the BME address numbers (0 - 5).
(Page 2-3)
4. Connect the BME COMM interconnecting
cable(s). (Page 2-3)
5. Connect the RS-232/RS-422 cable to the serial
port of BME #0. (Page 2-3)
6. Connect the AC Power cable(s) to the BME(s).
(Page 2-3)
7. Apply AC power to the BMEs and Verify
Normal Power-Up. (Page 2-3)
8. Do the steps under “After Hardware
Changes” on Page 5-13.
9. Connect cables to BMEs (video, sync and/or
audio cables). (Page 2-5)
The procedure for adding an Audio BME follows.
Adding a Matrix 6400 Audio BME
The Matrix 6400 Audio BME may be installed in a
rack with an existing Matrix 3200/6400 system, or
it may be installed in a different location. BMEs
may be separated by up to 12 feet and rack
mounting is NOT required. If the Audio BME is
going to be rack mounted with other BMEs, they
may be mounted in any order within a rack or
MATRIX 6400
WIDEBAND VIDEO
MATRIX 6400
WIDEBAND VIDEO
MATRIX 6400
WIDEBAND VIDEO
MATRIX 6400
SYNC
MATRIX 6400
SYNC
MATRIX 6400
AUDIO
POWER SUPPLIES COMMUNICATIONS
PRIMARY TX
RS232 BME REMOTE
SYSTEM
STATUS
REDUNDANT RX
DIAGNOSTICS
+V
-V
POWER SUPPLIES COMMUNICATIONS
PRIMARY TX
RS232 BME REMOTE
SYSTEM
STATUS
REDUNDANT RX
DIAGNOSTICS
+V -V
POWER SUPPLIES COMMUNICATIONS
PRIMARY TX
RS232 BME REMOTE
SYSTEM
STATUS
REDUNDANT RX
DIAGNOSTICS
+V -V
POWER SUPPLIES COMMUNICATIONS
PRIMARY TX
RS232 BME
SYSTEM
STATUS
REDUNDANT RX
DIAGNOSTICS
+V -V
POWER SUPPLIES COMMUNICATIONS
PRIMARY TX
RS232 BME
SYSTEM
STATUS
REDUNDANT RX
DIAGNOSTICS
+V -V
POWER SUPPLIES COMMUNICATIONS
PRIMARY TX
RS232 BME REMOTE
SYSTEM
STATUS
REDUNDANT RX
DIAGNOSTICS
+V -V
FPC-1000
RGB
MUTE
AUDIO
MUTE
Figure 5-10.A