IPL EXP I/O Series • Hardware Features and Installation
13
Mounting to rack rails
using a ZipClip
1.
Fasten the ZipClip 200
mounting clip to a rack
rail using two rack screws
as shown in the diagram
at right.
2.
Insert the bottom of the
EXP down into the clip,
starting with one end.
3.
Pivot the other end
toward the clip and press
until the clip snaps into
place.
Furniture mounting
NOTE:
The ZipClip is
shipped with a set of four
wood screws.
1.
Attach the ZipClip to the
mounting surface using two or
more wood screws (see
1
at
right). Make sure the clip is
oriented with the appropriate
side facing the mounting
surface of the furniture and with
the tab accessible from the
front of the furniture.
2.
Insert the EXP into the ZipClip
2
as described previously and
press to snap it into place.
Inside
Rack
Side of Rack
ZipClip 200
Back of
Rack
IPL EXP 200
2
1
Under a Desk
Ports, Addressing, and Connections
ATTENTION:
•
Installation and service must be performed by experienced personnel.
•
L’installation et l’entretien doivent être effectués par du personnel expérimenté.
Attach cables using the wiring diagrams in this section as a guide. See the
based Configuration and Control
section starting on page 31 and the
Global Configurator Help File
and
Toolbelt Help File
for information about Global
Configurator and Toolbelt, which you must use to set up the unit.
Summary of Contents for IP Link IPL EXP 200
Page 2: ...Safety Instructions...
Page 6: ......