background image

2

g

 

Power connector

 — Connect an IEC power cord between the included 12 VDC 

power supply and a 100-240 VAC, 50-60 Hz source. Connect the power supply to 
either unit as shown at right. Use the included tie-wrap to strap the cord to the 
captive screw connector.

NOTE:

 

Only one power supply is required. A single power supply 
connected to either unit in the pair powers both units. A power 
supply is included with each transmitter.

Operation

After all devices are powered up, the system is fully operational. See the definitions 

Rear Panel

Rear Panel

Front Panel

Front Panel

POWER

12V
         

0.6 A MAX

2

1

 

of the power indications (shown at right), below:

a

 

Power LED (front panel)

 —

Amber

 — The unit is receiving power, either locally or remotely (on the DTP cable).

Green

 — The unit is powered on and is receiving an active HDMI signal, either on 

the HDMI input if a transmitter, or transmitted on the DTP cable if a receiver.

b

 

Power LED (rear panel)

 —

Amber

 — The unit is receiving power remotely (on the DTP cable).

Green

 — The unit is receiving power locally.

If any problems are encountered, verify that the cables are routed and connected properly. If your problems persist, call the 
Extron S3 Sales and Technical Support Hotline that is closest to you, at the number shown below.

LockIt™ Lacing Brackets

Use an included LockIt Lacing Bracket to securely fasten an HDMI cable to each device as follows

.

1. 

Plug the HDMI cable into the panel connection.

2. 

Loosen the HDMI connection mounting screw from the panel enough to allow the LockIt 
lacing bracket to be placed over it. The screw does not have to be removed.

3. 

Place the LockIt lacing bracket on the screw and against the HDMI connector, then tighten the 
screw to secure the bracket.

ATTENTION

:

  Do not overtighten the HDMI connector mounting screw.  The shield 

it fastens to is very thin and can easily be stripped.

4. 

Loosely place the included tie wrap around the HDMI connector and the LockIt lacing bracket 
as shown.  

5. 

While holding the connector securely against the lacing bracket, use pliers or similar tools to 
tighten the tie wrap, then remove any excess length.

Power Supply

Output Cord

Ridges

Smooth

Captive

Screw

Connector

 3"
16 (5 mm) Max.

SECTION  A–A

A

A

68-2244-50 
Rev 

A

 

07 12

3

3

1

2

4

5

Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron USA - West 

Extron USA - East 

+1.714.491.1500 +1.919.850.1000 
+1.714.491.1517 FAX 

+1.919.850.1001 FAX

Extron Europe
+800.3987.6673 
(Inside Europe Only)
+31.33.453.4040 
+31.33.453.4050 FAX

Extron Asia
+800.7339.8766  
(Inside Asia Only)
+65.6383.4400
+65.6383.4664 FAX

Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX

Extron China
+4000.398766  
Inside China Only
+86.21.3760.1568 
+86.21.3760.1566 FAX

Extron Middle East
+971.4.2991800
+971.4.2991880 FAX

Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX

Extron India
1800.3070.3777 
Inside India Only
+91.80.3055.3777 
+91.80.3055.3737 FAX

© 2012 Extron Electronics   All rights reserved.   

www.extron.com

DTP HDMI 230 • Setup Guide (Continued)

Reviews: