HD 4K 110 • Installation
3
Installation
This section provides installation instructions for the HD 4K 110, including:
•
Mounting
•
Cabling
Mounting
ATTENTION:
•
Installation and service must be performed by authorized personnel.
•
L’installation et l’entretien doivent être effectués par le personnel autorisé
uniquement.
•
The unit must be installed in accordance with the National Electrical Code and with
local electrical and safety codes.
•
L’unité doit être installée conformément au National Electric Code et aux normes
électriques et de sécurité locales.
•
The
HD 4K 110 AAP
can be installed in an Extron two-gang, four-gang, or half rack
width AAP frame. The AAP frame can can be mounted in a wall or furniture using a wall
box or mud ring (see “Mounting a Wall Box”
below, or
Mounting a Mud Ring
on page
5).
The HD 4K 110 AAP can also be installed in the faceplate of another Extron device that
accepts double-space AAPs (see the mounting instructions for the device).
•
The
HD 4K 110 D
can be installed in a standard or compact one-gang wall box or
mud ring (see “Mounting a Wall Box”
below, or
Mounting a Mud Ring
on page 5).
UL Guidelines
•
The Extender must be installed in an Underwriters Laboratories (UL) listed junction box.
The UL-approved electrical wall box (junction box) is not included with the unit; the
installer is responsible for obtaining and installing the box.
•
The unit must be installed in accordance with the National Electrical Code and with local
electrical codes.
Mounting a Wall Box
NOTES:
•
Choose a location that allows cable runs without interference.
•
Allow enough depth for the wall box and the cables.
•
Install the cables into the wall, furniture, or conduits before installing the wall plate.
To mount the HD 4K 110 using a wall box:
1.
Place the wall box against the installation surface and mark the guidelines for the
opening.
NOTE:
If a wall box is not available to use for a template, use the
Decorator-Style
Template Dimensions
on page 10 to create a template. If installing directly into
furniture, cut out the center portion of the template.
