Extron electronics FOXBOX Rx DVI MM, User Manual, Page: 16 / 50

FOXBOX Tx / Rx • Installation and Operation 8
Connections and Configuration
Transmitter Features
FOXBOX Tx VGA Rear Panel
FOXBOX Tx DVI Plus Rear Panel
Front Panel
Front Panel
FOXBOX Tx VGA
RGB OVER TEMP AUDIO
CONFIG
OPTICAL
Rx Tx
LINK LINK
AUDIO
RGB INPUT
FOXBOX Tx VGA
RS-232
OVER FIBER ALARM
Tx Rx 1 2
12V
1.0A MAX
POWER
DVI OVER TEMP
AUDIO
CONFIG
OPTICAL
Rx Tx
LINK LINK
AUDIO
DVI-D INPUT RS-232
OVER FIBER ALARM
Tx Rx 1 2
FOXBOX Tx DVI Plus
FOXBOX Tx DVI Plus
12V
1.0A MAX
POWER
A A
G G C C D D E E
D D E E
H H I I
G G B B C C H H I I
F F
F F
Figure 2. FOXBOX Tx Transmitter Features
A RGB and YUV Input port (see below) F Optical port and LEDs (see page 10 )
B DVI-I Input port (see below) G Configuration port (see page 10 )
C
Audio port (see below)
H
Power connector (see page 10 )
D RS-232 Over Fiber port (see page 9 ) I Indicators (see page 11 )
E Alarm Outputs port
(see
page 9
)
NOTES:
• The FOXBOX Tx VGA/YUV looks similar to the FOXBOX Tx VGA, with the exception
of the name on the unit and the label on the input connector.
• The FOXBOX Tx DVI (non-Plus) looks similar to the FOXBOX Tx DVI Plus, with the
exception of the name on the unit.
A RGB and RGB/YUV Input port
FOXBOX Tx VGA
— Connect an analog VGA-UXGA RGB video source to this 15-pin
HD female connector.
FOXBOX Tx VGA/YUV — Connect bi-level or tri-level sync YUV video or an analog
VGA-UXGA RGB video source to this 15-pin HD female connector.
B DVI-I Input port (FOXBOX DVI only) — Connect a single link of DVI-D to this
DVI-I connector (see DVI connector (FOXBOX DVI) on page 15 for pin assignments).
NOTE: The FOXBOX DVI accepts only the digital signals on the DVI-I Input
connector. The analog pins on the port are not connected.
C Audio port
— Plug an audio input into the transmitter via this stereo mini jack connector.
NOTE: See figure 3 to identify the
connector tip, ring, and sleeve when you
are making connections for the transmitter
from existing audio cables. A mono audio
connector consists of the tip and sleeve.
A stereo audio connector consists of the
tip, ring, and sleeve.
Tip (L+) Sleeve (Gnd)
Tip (L+)
Ring (R+)
Sleeve (Gnd)
Figure 3. TRS Connector Wiring
The input audio level can be set via RS-232 control (see Remote Control on page 20).