Extron electronics FOXBOX Rx DVI MM, User Manual, Page: 19 / 50

FOXBOX Tx / Rx • Installation and Operation 11
I
Indicators (see figure 2 on page 8) —
Power LED
— Indicates that power is applied to the unit .
Over Temp LED — Indicates that the unit is operating at a dangerously high
temperature (approximately 167 °F [75 °C]) and that equipment damage is imminent.
RGB (FOXBOX VGA) , RGB/YUV (FOXBOX VGA/YUV) , or DVI (FOXBOX DVI) LED —
Indicates that the transmitter detects a signal on its video input, as follows:
RGB LED — Horizontal sync (H) (for RGBHV video) or Green (Sync on green) (G)
(for RGsB or RsGsBs video)
RGB/YUV LED
— Horizontal sync (H) (for RGBHV video) or luminance (Y) (for
component video)
DVI LED — DVI video input
Audio LED — Indicates that the transmitter detects a low level audio signal for a short
period of time. It goes dark if the audio signal drops below the minimum threshold for a
short period of time.
Receiver Features
FOXBOX Rx VGA Rear Panel
FOXBOX Rx DVI Plus Rear Panel
Front Panel
Front Panel
DVI OVER TEMP
AUDIO
CONFIG
OPTICAL
Rx Tx
LINK LINK
AUDIO
DVI-D OUTPUT RS-232
OVER FIBER ALARM
Tx Rx 1 2
12V
1.0A MAX
POWER
MODE
FOXBOX Rx VGA
RGB OVER TEMP
AUDIO
CONFIG
OPTICAL
Rx Tx
LINK LINK
AUDIO
RGB OUTPUT
FOXBOX Rx VGA
RS-232
OVER FIBER ALARM
Tx Rx 1 2
12V
1.0A MAX
POWER MODE
FOXBOX Rx DVI Plus
FOXBOX Rx DVI Plus
J J Q Q L L M M N N
M M N N
P P S S
Q Q K K L L P P
R R
R R S S
O O
O O
Figure 4. FOXBOX Rx Receiver Features
J RGB output port (see page 12 ) O Optical port and LEDs (see page 12 )
K DVI-I output port (see page 12 ) P Mode switch (see page 13 )
L
Audio port (see page 12 )
Q
Configuration port (see page 14 )
M RS-232 Over Fiber port (see page 12 ) R Power connector (see page 14 )
N Alarm Outputs port
(see
page 12
)
S Indicators
(see
page 14
)
NOTE: The FOXBOX Rx DVI (non-Plus) looks similar to the FOXBOX Rx DVI Plus, with
the exception of the name on the unit.