Extron electronics FOX3 T 201, User Manual

Page: 13 / 51

FOX3 T 201 Transmitter • Installation and Operation 5
Installation and
Operation
This section details the installation of the FOX3 T 201 transmitter, including:
•
Installation Overview
• Rear Panel Features
• Connector and Cable Details
• Front Panel Features
•
Operation
• Audio Configuration
Installation Overview
Follow these steps to install and set up an Extron FOX3 T 201 transmitter for operation:
c
Turn off all of the equipment. Ensure that the video source and the output display are all
turned off and disconnected from the power source.
c
Mount the transmitter (see Equipment Mounting on page 42).
c
Connect the cables and configure the units (see “Rear Panel Connections”, starting
below).
c
Plug in the power supplies, then turn on the display and the input.
Rear Panel Features
Rear Panel Connections
RS-232
REMOTE
POWER
12V
--A MAX
Tx Rx G
A
OUT IN
B
OUT IN
RS-232
Tx Rx Tx Rx G
IR
HDMI
FOX3 T 201
R
AUDIO
CONTROL
INTPUTS
J J J H H H G G G C C C A A A E E E I I I F F F B B B D D D
LOOP OUT
LAN
Figure 2. FOX3 T 201 Transmitter Rear Panel Features
A
Power inlet
F
Control RS-232/IR port
B
Power LED
G
Remote RS-232
C
Audio input
H
LAN Ethernet port
D
HDMI input
I
SFP module and LEDs
E
HDMI Loop Out
J
Reset button
2