Setup Guide — FF 120T, cont’d
Extron
USA - West
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500
+1.714.491.1517
FAX
Extron
USA - East
+800.633.9876
Inside USA / Canada Only
+1.919.863.1794
+1.919.863.1797
FAX
Extron
Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050
FAX
Extron
Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664
FAX
Extron
Japan
+81.3.3511.7655
+81.3.3511.7656
FAX
Extron
China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566
FAX
Extron
Middle East
+971.4.2991800
+971.4.2991880
FAX
© 2009 Extron Electronics. All rights reserved.
68-1450-52
Rev. A
06 09
4
Step 7 — Installing the speaker in the ceiling
Refer to the illustration below.
a
. Replace the cover plate and tighten the two cover screws.
b
. Install the T-rail crosspiece into the ceiling opening up against the cut tile.
c
. Set the speaker into place so that the edges are hidden by the support rails.
Step 8 — Attaching the seismic support lines
If seismic support lines are being used, connect a line through the seismic anchor (or integrated
line retainer) on the cover plate and attach it to one of the seismic bendout tabs (the center tab is
preferred) located on either side of the speaker. Use a small screwdriver or similar tool to bend
out the tab.
N
Observe all applicable building codes and local ordinances when installing the speaker.
Step 9 — Power up
After checking all speaker connections power up the amplifier.
Anchor this end to a
suitable secure point.
Route the cable through
the seismic anchor ring
and bendout tab.
Seismic Safety
Cable
Bend Up Tab
Repeated bending of the tab
may cause it to break off.
T-rail (1)