DXP HD 4K PLUS Series • Operation
27
NOTE:
While the DXP is in this mode, you cannot create ties, mute an output, set
the RS-232 baud rate, or save or recall a preset. Before attempting any of these
procedures, ensure that the unit is
not
in power save mode 2 (the Video LED for the
I/O
button blinks green continuously and no other front panel buttons respond).
Resetting
There are several methods by which you can reset the DXP, and some of these methods
allow for four levels of resetting. The following reset methods are available on the DXP:
•
Front panel buttons
(see
Resetting the System from the Front Panel
)
•
Rear panel Reset button
Resetting Using the Rear Panel Reset Button
on
the next page)
•
SIS commands
(see the
Table for SIS Commands, page 51)
•
PCS
(see the program help file)
Resetting the System from the Front Panel
A system reset (also known as a “hard reset”) does the following:
•
Clears all ties and presets.
•
Clears all video and audio setup and mutes.
NOTE:
The system reset does
not
reset the internet protocol (IP) settings, replace
user-installed firmware, or reset the unit name to the factory default.
The front panel reset is identical to the
E
ZXXX
}
SIS command (see the
To reset the switcher to the factory default settings (see
on the next page):
1.
Disconnect power from the DXP, then immediately reconnect it. All front panel LEDs
blink four times, then turn off, leaving the I/O LEDs lit red.
2.
Immediately press and continue to hold the
I/O
button while the front panel LEDs do
the following:
a.
The Input Signal and HDCP LEDs blink in order in a clockwise, circling pattern.
b.
All front panel LEDs blink three times, then turn off.
c.
The I/O Video LED lights green.
