Extron electronics DVS 150, User Manual, Page: 16 / 38

Installation, cont’d
DVS 150 Installation 2-6
Configuring the Scaler
The LCD on the front panel of the scaler provides access to a menu that allows you
to configure the scaler.
• To access the menu, press the input button and the rate button simultaneously,
and hold them for two seconds. The Autoswitch menu appears in the LCD.
• To step through the menus, press the input button.
• To exit the menu, step through the menus until the Detail menu appears, and
then press the input button one more time. Or, wait eight seconds without
pressing any buttons or turning the adjust knob, and the menu reverts to the
default screens.
Configuration settings
Autoswitch (AUTOSW) — If set to On, automatically selects the input source that
uses the highest video quality. If set to Off, allows you to manually specify
the input source by pressing the input button on the front panel. To toggle
between On and Off, turn the adjustment knob while the Autoswitch menu is
displayed. By default, autoswitch mode is Off.
Top blanking (TOPBLANK) — Removes noise and unwanted information, such as
tape head switching and closed captions, from the top of the screen. To
change the top blanking level, turn the adjustment knob while the Top
blanking menu is displayed, until the unwanted information no longer
appears.
Bottom blanking (BOTBLANK) — Removes noise and unwanted information,
such as tape head switching and closed captions, from the bottom of the
screen. To change the bottom blanking level, turn the adjustment knob while
the Bottom blanking menu is displayed, until the unwanted information no
longer appears.
Horizontal sync polarity (H-SYNC) — Changes the polarity of the horizontal sync
signal to allow any projector to distinguish the scaler input from a standard
RGB input. To toggle between Positive and Negative, turn the adjustment
knob while the Horizontal sync menu is displayed. By default, the horizontal
sync polarity is set to Negative.
Vertical sync polarity (V-SYNC) —
Changes the polarity of the vertical sync signal
to allow any projector to distinguish the DVS 150 input from a standard RGB
input. To toggle between Positive and Negative, turn the adjustment knob
while the Vertical sync menu is displayed. By default, the vertical sync
polarity is set to Negative.
Sync on green (SOG) — If set to Yes, provides sync on green (RGsB or SOG)
output. If set to No, provides RGBS or RGBHV output, depending on the
attached cables. To toggle between Yes and No, turn the adjustment knob
while the Sync on green menu is displayed. By default, Sync on green is set
to No.
Still (STILL) — If set to On, provides enhanced resolution for easier viewing of text
and other motionless video. If set to Off, provides optimized motion video.
To toggle between On and Off, turn the adjustment knob while the Still menu
is displayed. By default, still mode is set to Off.
Detail (DETAIL) — Applies a filter to improve the image’s level of detail. To
switch between 1 (low), 2 (medium), and 3 (high), turn the adjustment knob
while the Detail menu is displayed. By default, detail mode is set to 3.